ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.

Author: Mibei Voodoozahn
Country: Laos
Language: English (Spanish)
Genre: Politics
Published (Last): 18 November 2005
Pages: 90
PDF File Size: 6.77 Mb
ePub File Size: 4.91 Mb
ISBN: 133-2-58093-341-8
Downloads: 20477
Price: Free* [*Free Regsitration Required]
Uploader: Kazrazuru

All base asmt specimens shall be removed with the axis of the specimens longitudinal to the direction of primary metal? JIS G Carbon steel pipes for pressure service. These fittings are for use in high-pressure gas and oil transmission and distribution systems. Section V, Nondestructive Examination.

BoxArlingate Ln. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. There sults shall conform to Table 1 for either.

No cracks shall be permitted.


Internal and external surfaces shall be examined when size permits accessibility. Combining values from the two systems may result in nonconformance with this specification. Current edition approved Nov. This does not preclude the use of deoxidizers. After the removal of any cracks, the qstm shall be re-examined by the original method.


Electrodes for the shielded metal-arc process shall be of the low-hydrogen type. Unless the order speci?

The material for fittings shall be fully killed fine — grain material made by a. No sstm shall be permitted. Notch Toughness Properties 8.

The nickel content of the deposited weld metal. Only the side wall area of the tees need be examined.

ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.

One or more of the supplementary requirements may be specified in the order. Wrought austenitic and austenitic-ferritic duplex stainless steels without specific inspection requirements BS EN Butt-welding pipe fittings Part 4: The values qstm in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

Materials shall be heat treated by normalizing, quenching, and tempering or stress relieving. These fittings are for use in high — pressure gas and oil transmission asrm distribution system.



This abstract is a brief summary of the referenced standard. Within the text, the SI units are shown in brackets. NOTE 1—For purposes of identi? If used on small? Materials and Manufacture … Research use only,Commercial use is prohibited.

JIS G Arc welded carbon steel pipes. What can I do for you? A refers to the high yield strength of the fittings.

Carbon steel WPHY 65 buttweld fittings, ASTM A WPHY GR 65 Pipe Fittings Manufacturer, Exporter.

Committee A01 has identi? After the removal of any cracksthe a80 shall be re. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

All fittings shall be furnished in the heat-treated condition. By Sea or By Land Packing: A number in parentheses indicates the year of last reapproval.