GY520 MANUAL PDF

Futaba GY Pdf User Manuals. View online or download Futaba GY Instruction Manual. Nstruction, Anual • Read online or download PDF • Futaba GY User Manual. The chart below works for almost all helicopters but you should consult your helicopter manual if you are not sure. Note that I have seen.

Author: Dubei Yozil
Country: Spain
Language: English (Spanish)
Genre: Video
Published (Last): 18 August 2005
Pages: 164
PDF File Size: 5.33 Mb
ePub File Size: 7.72 Mb
ISBN: 299-3-63032-724-9
Downloads: 66775
Price: Free* [*Free Regsitration Required]
Uploader: Dishakar

If not, hold the button down to enter setup mode. Use the ‘clear’ button to set the values to zero.

Futaba GY Manuals

In a moment you will turn on the receiver. Note that passwords are case-sensitive. Please enter a valid email address for yourself. The light on the gyro will turn solid Blue. This will set it up for the next step. When you connect the servo plug to the gyro you need the link to be off so it does not bind.

There are three things that need to be connected.

A high framerate setting on a low framerate servo will damage the servo in a minute. Do not stick the gyro to the side of the frameset. When I went to hover, the tail oscillated big time. To select both sides flip the GEAR switch.

FUTABA GY520 Manuals

Look at the picture on the right. Do not tie the soft rubber line down to the helicopter, close to the gyro. Adjust to get the maximum travel without binding. One direction will be blue and the other direction is red.

  KUAN-YIN THE CHINESE TRANSFORMATION OF AVALOKITESVARA PDF

The black wires of every plug all should be on the same side of the receiver.

Once you have the servo type correctly set then hold the button on the gyro for 2 seconds to move to the next function. Then the light will stay on solid. For small class helis use the thin foam pad. This needs to occur when you move the stick left as well as right.

GY Setup – HeliFreak

So it is important to make the checks on the bench so you do not risk damaging the helicopter. The instructions state that you should set it up in HH mode if you are going to fly in HH mode-this is incorrect. Most other receivers have it mznual channel 5. In the picture you see the link it bent down, the 90 degree angle is in reference to the unbent part of the tail control rod.

With the rudder link disconnected from the servo. On the small helicopters a gain of around 50 is normal.

Please click one of the Quick Reply icons in the posts above to activate Quick Reply. Hold the gyro button in for 2 seconds to get to the 5-Blink mode.

  ECONOMIA DEL LAVORO BORJAS PDF

Quote yy520 in reply? Note that I have seen common problems with the tail blades grips flipped the wrong direction and the tail belt twisted the wrong direction. Verify the gyro is in Ggy520 Hold mode, light on the gyro is Red.

Next disconnect the rudder link from the tail servo. Quickly press and release the gyro button to change the direction.

If not then go back to step 1 and start again.

FUTABA GY520 Instruction Manual Page 23

I’ve never setup a Futaba tail gyro; any ideas? Move full left and full right and verify you do not hear the servo strain from binding.

On my miniTitan you can see in the right picture that the tail servo is mounted to the tail boom. With it in this position the gyro will be in heading hold maunal the gear switch up position 0. Power up the radio and the receiver. With the main blades rotating clockwise as seen from above, the tail rotor should rotate counter-clockwise as viewed from the right side.

The black wires will be away from the labels.